c2260a1-0015 tcxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-02-15 index : 10 printed 2008-06-25 ? page 1 of 4 vectron international ? product specifications nominal frequency (f0) 20 mhz frequency stabilities parameter frequency stability operating temp. range over all (df/f0) -20 to 20 ppm vs. operating temp. range (df/f@25 c) -3.5 to 3.5 ppm -40 ... 85 c parameter value condition initial tolerance (df/f0) -1 to 1 ppm @25 c vs. supply voltage change (df/f) -0.3 to 0.3 ppm static; 3.3 v 5 % vs. load change (df/f) -0.2 to 0.2 ppm static; load 10 % vs. aging / 20 years (df/f) < 10 ppm @ 40 c holdover 24 h 4.6 ppm 24 hrs drift: <+/-0.5ppm over all: <+/-20ppm for all causes @20years aging rf output parameter value condition signal lvcmos load 15 pf 10 % rise time < 9 ns @ 10 to 90 %vout fall time < 9 ns @ 90 to 10 %vout duty cycle 45 / 55 % @ 1.65 v v lo w x < 0.33 v v high x > 2.97 v sub harmonics <- 80 dbc spurious <- 80 dbc supply voltage parameter value condition supply voltage (vs) 3.3 v 5 % current consumpt ion steady state < 24 ma @ vsnom & 25 c additional parameters parameter value condition phase noise < -85 dbc/hz 10 hz max < -110 dbc/hz 100 hz values < -125 dbc/hz 1000 hz < -135 dbc/hz 10 khz < -135 dbc/hz 100 khz start-up time < 10 ms a dditional information phase noise typ.: -89dbc/hz@ 10hz; -110dbc/hz@100hz; -140dbc/hz@1khz; -153dbc/hz@10khz and -154dbc/hz@100khz processing & packing handling &processing note additional environmental conditions tensile strength of leads din iec 68 t2-21 (ua 1) flexibility of leads din iec 68 t2-21 (ub) sealing test a nicht dicht (not hermetically sealed) solderability din iec 68 t2-20 (ta) 100% rohs compliant solvent resistance en 60068-2-45, test xa washable device
c2260a1-0015 tcxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-02-15 index : 10 printed 2008-06-25 ? page 2 of 4 vectron international ? product specifications absolute maximum ratings parameter min typ max units condition operable temperature range -40 85 c storage temperature range -55 105 c enclosure type g211a height 2.3 mm all units in mm pin connections pin 1: n.c. pin 2: gnd(case) pin 3: rf-output pin 4: vs (supply voltage) marking 2a-015 20m000 *vayyww - - * pin-1 marking
c2260a1-0015 tcxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-02-15 index : 10 printed 2008-06-25 ? page 3 of 4 vectron international ? product specifications reflow profile profile feature pb-free assembly/sn-pb assembly average ramp-up rate (tl to tp) 3c/second max. preheat -temperature min (tsmin) 150c -temperature min (tsmax) 200c -time (min to max) (ts) 60-180 seconds tsmax to tl - ramp-up rate 3c/second max. time maintainted above - temperature (tl) 217c - time (tl) 60-150 seconds peak temperature (tp) max 260c time within 5c of actual peak temperature (tp) 20-40 seconds ramp-down rate 6c/second max. time 25c to peak temperature 8 minutes max. note: all temperatures refer to topside of the package, measured on the package body surface. a dditional information this smd oscillator has been designed for pick and place reflow soldering.
c2260a1-0015 tcxo vectron international www.vectron.com 49-07268-801-281 fax 49-07268-801-0 tel germany d-74924 neckarbischofsheim landstrasse vectron international gmbh & co. kg modified 2007-02-15 index : 10 printed 2008-06-25 ? page 4 of 4 vectron international ? product specifications standard shipping method tape width w [mm] quantity per meter quantity per reel p [mm] a [mm] b [mm] k [mm] 16 125 750 8 5.4 7.4 2.7 notes: unless otherwise stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency control voltage, load, temperature (25c). subject to technical modification.
|